WiseCable™ Estate Series Cable Railing Kit

Use the WiseCable^® Estate WC-ES Series for decks with dedicated end posts for each run where the posts are situated such that, the back sides of the posts are all accessible. Meaning you can use a through-the-post configuration. This fitting is placed and concealed within a pre-drilled hole in the wood end post (a minimum of 3” of clearance must exist on the back side of the post to allow installation of the receiver). The stud is swaged onto one end of the cable and is inserted and threaded into the receiver installed in the end post. Tension is created by rotating the receiver (with a hex wrench inserted into its broached end) and drawing the stud into the receiver.

What's included in the kit?

10 Pack:
For use with 36" posts, cables spaced vertically 3" on center. You get 10 packs of cables in the length you choose.

12 Pack:
For use with 42" posts, cables spaced vertically 3" on center. You get 10 packs of cables in the length you choose.

14 Pack:
For use with 48" posts, cables spaced vertically 3" on center. You get 10 packs of cables in the length you choose.

Tools needed for WiseCable^® Estate WC-ES Series on level straight runs:

• 5/32 drill bit if 1/8” cable, 7/32 if 3/16”
• 29/64 drill bit for receiver and pull lock installation
• 3/16 wrench for tensioning receiver
• Cable cutting tool
• If using post protector tubes, 1/4 drill bit

When taking the WiseCable^® Estate WC-ES Series cable railing through a corner, do not bend the cable past 45⁰ at any one time. If turning 90⁰, a 2-step turn using a double corner post configuration is required as illustrated in the corner post instructions (view here).